Pay in 4 interest-free payments with Afterpay
Ships from trusted U.S. suppliers
Turn your Revolink Quick Release Mount into a no-drill Starlink Mini magnetic mount. Three rubber-coated magnets bolt through the mount's bolt pattern and hold it to any flat steel surface. Lift it off when you're done.
Compatibility
- Revolink Starlink Mini Quick Release Mount (sold separately)
- Holds on flat steel, bare or painted: car and truck roofs, hoods, steel van and RV panels, steel trailer skins
- Won't hold on aluminum, fiberglass, carbon or composite, including most truck caps, camper shells and Bronco hardtops
Quick test: if a fridge magnet won't stick, these won't either.
Driving While Installed: Hold depends on a flat, clean steel surface. Confirm all three magnets sit flat and pass a firm pull test before every drive. See the install guide for full instructions.
180 lb Combined Hold
Each magnet is rated for 60 lb of pull force. With the three spaced in a triangle across the mount, that's 180 lb of combined hold on flat steel.
Scratch-Safe Rubber Coating
A rubber jacket on each magnet protects painted finishes. Set the mount straight down, tilt it to remove, and keep both surfaces clean. Grit is what scratches paint.
5-Minute Install
M6 threaded stems bolt through the Quick Release Mount's pre-punched holes with the included washers and nuts. All you need is a 10 mm wrench.
What's Included
- 3 rubber-coated magnets, 60 lb pull each, M6 threaded stems
- 3 washers
- 3 M6 nuts
Revolink Satellite Gear is an independent accessory manufacturer, not affiliated with SpaceX or Starlink.
